corners for the slab edge

[JH75]

Hi,
I have a problem with the corners for the slab edge. Please see attached image. I though this had been fixed in RST2009?
I have checked -> the slab and slab edge are the same material.
And also I can't use the Linework tool for the corner line - it just doesn't recognize it

Thanks
J

[m20roxxers]

Have you set up the .ini file to show both hidden lines of the taper from the the base to the slab?

If not you may have to change this option to only show the option you need.

[JH75]

Thanks,
I have tried all the different settings
All - All slab edges did show up
Itself - as show in the attached pic and I can't select the "corber line" with my Lineworks tool.
Other - It works OK. The "corner line" doesn't show up. The disadvantage is that i is the wrong line shown.
None - As expected no lines.

Are there any Reinit command like it is for Autocad? ie in Autocad you can type in Reinit and reload the pgp file.
Cheers,
J

[scowsert]

Well I can confirm seeing the same thing here. Revit 2009 Web Update 3.

[shatcher]

Have you set up the .ini file to show both hidden lines of the taper from the the base to the slab?

If not you may have to change this option to only show the option you need.
Where do I go to make these changes?

[m20roxxers]

If you go to where Revit is installed and open the programs folder you can open the Revit.ini file in notepad and add additional options, not sure what all or even half of them are.

Another one worth adding to your toolset.
http://forums.augi.com/showthread.php?t=19105&highlight=Allow+split+gap
invaluable for tilt construction.