Hole in the wall

[charliep]

I modified the base of a compound wall so I could 'slide' the inner leaf up. This has resulted in holes appearing in the wall at the base where the inner leaf should be. I've tried wrapping & not wrapping but doesn't seem to make any difference. Any ideas?

[ws]

Any chance you could you post a screenshot or picture?

[charliep]

Thanks William, i had to get the drawing out last night so in desperation I tinkered with the end wraps again. It worked but the trouble is I'm not too sure what I did to resolve it. I'll pay closer attention next time.

[ws]

I'd just been viewing the latest cadclips.com video series on Revit 2009 fundamentals which goes into unlocking wall layers in some depth - I didn't realise you could split, and slide up and down bits of wall layer or merge materials from adjacent layers.