Segmenting a curved wall

[aarong.200024]

Hi all,
Trying to find out if there is a way make a curved wall into segmented straight pieces? Our project has an auditorium which started with a curved stud wall and is now going to be segmented precast panels 10' wide. Is there a way to take the existing wall and turn it into these segments as they will have the same radius. Thanks.

[twiceroadsfool]

Nope, you have to redraw/Create Similar them... But then you can select the hosted elements and "Rehost" them, so you dont lose data/door information in them...

[aarong.200024]

Nope, you have to redraw/Create Similar them... But then you can select the hosted elements and "Rehost" them, so you dont lose data/door information in them...

I was afraid of that :) Thanks for the info.

[aaronrumple]

You could turn it into a cuved curtain wall where the panels would be the precast. This will allow you to segment the wall at each curtain grid point.