Mark up length doesn't show up in dwf file

[diesellam]

Please see the attached PDF file.
I put 3 mark up lengths in the clouded area.
They show up in the markup palette, but not in the clouded area, why?

How can I make them show up in the clouded area?

[RobertB]

<snort> Why are you posting a PDF in a DWF forum?!

:veryevil:

[diesellam]

The PDF file illustrates the problem I was facing in the DWF file.

What's the problem posting a PDF file instead of other file format?

[RobertB]

No "problem". It's just that it is ironic.

Did your measurements appear in the editor while drawing and then disappear?

[diesellam]

Yes, you are right. It showed up in the editor, then it disappeared. But they do show up in the Markups palette though. OK, I just uploaded the DWF file. Please see the attached file. Maybe you can understand what the problem was by opening up the actual 3D DWF file. The three markup dimensions I did, none of them showed up in View 5, why?

Another question, if I make certain elements to show as transparent, even after I save it and exit, when I reopen it, those elements will restore back to non transparent. Is there a way you can make it shown as transparent permanently?

Thanks in advance.