Cut Hatch

[DO-PRE]

I have a 4'8" high cmu wall and in plan the cut hatch wont show. My cut plane is at 4', and thoughts.

Thanks,

Dan

[Carlos GT]

Try this: take your wall to the upper level and give it a negative offset. For example, if the next level is 10 feet, give you wall a -5'-4" offfset.

[brethomp]

When using the "Unconnected" option for the walls top constraint, Revit assumes you want to show it as a partial height wall. If you set the top constraint back to a level, Revit will cut it like a normal wall. You could do as Calos says, and associate it with the level above, but if you change your floor-to-floor distance, you will need to remember to change this wall. If you want this wall to always be 4'8" tall, set the top constraint to the same as the bottom constraint, and the Top Offset to 4' 8".

[DO-PRE]

Great, showing correctly now.

Thanks,

dan