floor......slope arrow

[ntnik]

can i go two ways with that??........i'm putting a swale in and i want a lower point at the center...ant an arrow down the length then i want the sides to slope to center......the length of the swale ....was going to set it where i need it and match my topo to it ( wanted to attach a few spot elevations to it then i'd know where i wanted my topo to be)

[jarosa]

You can't use the slope arrow in two directions on one slab. You can do two slabs if you want to use the slope arrows. but another way to do it is to modify the slab by adding points. Edit the slab and check the options bar.
gl hth,
John

[Andre Carvalho]

No, you can only have one slope arrow per floor.

Why don't you try using the slab sub element tool. After you draw the slab, select it and you will see the floor sub element icons showing in the design bar. You can add and modify levels for points and lines.

Andre Carvalho