Titleblock too small!!!

[jcapp]

I am having trouble with RSS 2009, I have the architects titleblock in my model on a sheet with 1/8" views. The plots all come out somewhere between 3/32" & 1/8". I am not sure what is happening. The architects sheets print fine.

Has anyone seen this before?

thanks
joe

[kathy71046]

Have a look at the actual print setup in the architect's drawing and set yours up the same.

Are you able to print with your own titleblock at a normal size?

Is there something on your view that is way off the sheet and your setup is scaling to fit?

[jcapp]

thanks kat, i did look at the architects set-up, but could not find a clue

then i adjusted the paper placement and set it to plot at 100% and that resolved the issue

thanks

j