Sta,Off on Alignment to profile

[mlepelletier.182210]

Is there a way to pick a point on a alignment create a label on the alignment AND on the profile view associated to it?

I am laying out a 30" watermain with bends and deflections by hand in plan and profile.

I have all my bends layed out in plan view and now am trying to draw them in profile.

The only way I have been able to do this is find sta, offset on the alignment at the bend, go to the profile, draw a line at the station, do a offset, and put the bend at the offset line.

Thanks

[chris805_1996]

Horizontal Geometry Point in profile if the alignment is the same as the watermain and use PI labels for the bend. For vertical deflections use Profile Geometry Point labels.

[brian.hailey933139]

Or you can use the Profile Station From Plan transparent command.