saeborne
2009-03-03, 04:44 PM
Hi all,
In my Toposurface, I'm using the label contours tool to give my elevation levels.
The elevation numbers are oriented from lowest elevation to highest elevation... Which makes sense, but sometimes the numbers are reading upside down on my plan view. (See attached).
Anyway to "flip" these numbers?
Thanks,
Bryan
In my Toposurface, I'm using the label contours tool to give my elevation levels.
The elevation numbers are oriented from lowest elevation to highest elevation... Which makes sense, but sometimes the numbers are reading upside down on my plan view. (See attached).
Anyway to "flip" these numbers?
Thanks,
Bryan