sloping site compound wall

[preet29pawar]

Revit is new to me.With the help of Revit i'm working on my project.
I really dont know how to draw compound wall on sloping site ?
I have tried lot of options for same but, none of it help me.

[patricks]

Are you trying to make a retaining wall of some kind?

The last time I did that, I just created an elevation near the wall and edited the wall profile so that the top of the segmented retaining wall would follow the contours of the toposurface behind it.

This will only work for a straight wall, though. If the wall is curved, your best bet would be to make a separate wall for each individual coursing of block, and adjust the end points of each wall as needed to achieve the step-downs at each end of the wall. Most likely you will have to work in a combination of elevation, section, and 3D views to get it to look right.

[preet29pawar]

Hey .. thank you for your quick reply...
Right , Iam trying to make retainig wall.
I tried your suggesion, its help me.

[preet29pawar]

Here is new problem....
after modification of each wall ,I place parapet cap (edit assembly > parapet cap [profile] )
but parapet profiles following original wall profile. what should i do?

waiting for reply...


Ar. Preeti Pawar