Gable Roof

[stitch1778]

trying to do a gable roof that the peak is not in the middle so that one end is lower then the other.

also the face of the gable is split in 2 so that 2/3 of the gable face is 2' in front of the other 1/3 of the gable face

see attchment

[Martin P]

Do the roof(s) as an extrusion instead of footprint. If it buts up to another roof use "join geometry" to get rid of the join line where they meet.

or..... :lol:

Do it as a footprint, pick the line in sketch mode that is higher, go to its properties and change the plate offset from base.

Or.... :wink:

do it as one rectangular footprint, and use the "opening" function in the modelling tab to cut a chunk out where it is higher - or just draw it that way and make the slope defining the furthest out lines.

I think there is a tutorial on complex roofs, that should cover that type of roof? have a quick scan over it I am sure they do it in there. Hope you get it worked out :)

Martin

[stitch1778]

Thanks alot for the help worked great
:D