PDA

View Full Version : Problem Displaying Property Lines in 3D view



millerj
2009-03-10, 01:54 AM
Is it possible to get the property lines to display in the 3d view? I figured out that I could get them to display properly in the site view by placing the level of the 3D view at the lowest level. However I cannot figure out a way to get the property line to display in the 3d view. (Other than tracing over the property lines onto a regular level that is above the 3d view.) Is there a way to wrap the property lines to the contour that would keep them accurate? I have been trying everything and cannot seem to get anything to work.

d.stairmand
2009-03-14, 05:44 PM
We normally split the Topo at the Property Line. I see no other way of doing it?