Drafted work won't show when export DWG

[spiveylipsey]

I know this is vague but I will try to provide as much information as possible. When I export to DWG, all my links/backgrounds come out fine, but my drafted work (electrical receptacles) don't export at all. they are no where to be found - the settings for the corresponding linked file are the same as all the other linked files...any thoughts on where I might even begin looking to resolve this?

Thanks for any help, again I know it not much information but I'm pretty new at all this



!!!I just realized this is the ARCH section, sorry :(

[spiveylipsey]

PS - my work plots fine

[cporter.207875]

I had a similar problem this morning, but I think it was just a glitch. I turned off the revit link in my visibility settings and then re-exported to .dwg, and everything exported just fine. So... just to test it, I turned the link back on and tried again to export the whole view as it should be... and again, no problems. So, like I said, I think it was just a glitch.