pjhauff
2009-03-19, 04:53 PM
I am using Revit 2009. I have used Revit for a little over a year so I am not a newbie but still far from being an expert.
I have created a set of duplicate views from some floor plan views for the purpose of showing demo conditions on new demo sheets. When I copied these views (can’t remember if I used duplicate or duplicate with detailing) the section cuts came along with them. When I changed the phase filter on these new views to ‘Show Previous + Demo’ it had no effect on the section cut references. But when I drug the views onto the demo sheets, I got new section references for the demo sheets. These cuts were right on top of the section cuts from the original views. When I try to turn the demo cuts off in the floor plan views or vice versa, (using hide element) the cuts do not stay permanently off.
Is there a phase that I need to assign to the cuts themselves? Is there a different phase filter that needs to be applied to the demo or floor plan view? Is there some sort of view dependency that is interfering here?
I have created a set of duplicate views from some floor plan views for the purpose of showing demo conditions on new demo sheets. When I copied these views (can’t remember if I used duplicate or duplicate with detailing) the section cuts came along with them. When I changed the phase filter on these new views to ‘Show Previous + Demo’ it had no effect on the section cut references. But when I drug the views onto the demo sheets, I got new section references for the demo sheets. These cuts were right on top of the section cuts from the original views. When I try to turn the demo cuts off in the floor plan views or vice versa, (using hide element) the cuts do not stay permanently off.
Is there a phase that I need to assign to the cuts themselves? Is there a different phase filter that needs to be applied to the demo or floor plan view? Is there some sort of view dependency that is interfering here?