Wall Wrap Problem

[David Sammons]

I am having difficulty with some wall wraps. If anyone has a moment to look into this, please refer to the attached file. At the upper left corner of the plan, I can not get the wall to wrap properly. For some reason, a portion of wall is left out of the wrap at the corner.

Also, at the lower left corner, I want the brick veneer to wrap around the corner.

Dave S.

[beegee]

There is a 6 1/8" 2 hr partition in the top left corner , in phase 2 , which prevents to wall wrap. If you delete that, it wraps nicely.

As for the lower left corner, that is difficult to achieve. I would use a filled and drafted region to fix that.

[beegee]

This is the lower left corner, fixed, without using filled regions.

It takes a bit of playing around with and is difficult to put down in words, basically it involves making a new wall types for the brick skin and the cmu and using both disjoin wall wraps and join geometry, but it can be done.

If you pull apart the attached file you will see how.

[David Sammons]

beegee,

Thanks. I could not see the 6-1/8" partition in any view. In any case, I deleted it from the list of wall families in the project browser and the wall now wraps fine. Could you see the partition in plan view?

Also, thanks for the help with the lower left corner.

Dave S.

[beegee]

Could you see the partition in plan view?
.From hazy memory, I turned on all phases ( show all ) and it was visible in a 3D view.

Glad it helped.