Question about adding slab edge

[speedfreak5150]

Hi I followed the below instructions to create and load a new slab edge profile it work but it will lonely let me add a host sweep to 1 edge at time before ended the command is there a way to add the sweep to all slab edges u wish at once

Thanks Jared

First, you have to create a profile. Start a new family (File > New > Family > Profile) and draw it there. Once it is done, load it into the project and go to Modelling > Host Sweep > Floor Slab edge. Pick any one and go to Properties > Edit/New... > Duplicate > Give it a new name > select the profile you just created and loaded, to be used by the slab edge.

Andre Carvalho

[Carlos GT]

At the moment of insert your profile in the slab, just use the "tab" key to select the entire slab. (you might want to hit tab more than once)

[david_peterson]

I should tell you that RS doesn't like to do slab edges of different extensions off the beam line. So if one edge is 6" and around the corner is 1'-0" off the beam line, you're going to run it some issues.