Stacked Wall Display Problems

[David Sammons]

When using 'stacked walls' with discipline set to 'architectural', the walls designated as 'bearing' will display. However, when I change the discipline to 'structural', some of the stacked walls do not display even though their components have been designated as 'bearing'

Has anyone else had this problem? Does anyone know the email address for Revit Technical Support so that I can send my file to them?

Dave S.

[cmahoney]

Stacked walls do not have the Structural usage parameter that is found with other types of walls. Each sub-wall of a stacked wall can have a different usage value. This is an instance parameter, not a type parameter, so each sub-wall of each stacked wall will need to be changed independently. If you have done this and it still does not behave as you expect, please open a support request.

To make a support request you should log into the Autodesk Subscription Center. There is a link on the Autodesk (http://www.autodesk.com) home page and in my signature below.