Application Erro in 2010

[Henry D]

Has anyone else had this application error message? The program terminates...Project works fine in 2009.

[patricks]

Has anyone else had this application error message? The program terminates...Project works fine in 2009.

Haven't seen that particular message in 2010, but I do see that message come up ALOT a few seconds after CLOSING 2009 in the afternoon before going home. It doesn't affect my actual work in 2009, it just comes up immediately after closing it.

I believe 2009 has some memory leak issues that 2008 did not have, as I often have problems running Photoshop or even opening a PDF with Revit running at the same time, despite having 4 GB RAM and quad processors. I never had problems like that on the same machine when we were using 2008.

[Henry D]

Thanks...ahh so it's a matter of not having enough memory. I also have 4G of Rm and a quad processor. It's probably because I had the project open in both 2009 and 2010 at the same time. I was comparing the difference in spinning the models around with shadows. 2010 is way smoother and the shadows don't momentarily disappear like in 2009. So I had something nice to say about 2010:lol:!

[patricks]

Thanks...ahh so it's a matter of not having enough memory. I also have 4G of Rm and a quad processor. It's probably because I had the project open in both 2009 and 2010 at the same time. I was comparing the difference in spinning the models around with shadows. 2010 is way smoother and the shadows don't momentarily disappear like in 2009. So I had something nice to say about 2010:lol:!

Yes spinning the model with shadows on is MUCH faster and smoother for me if hardware acceleration is turned on, but I'm getting lots of fatal errors also.