Door swing dispaly problem in linked models

[sifuentes]

Hi,

We have a campus with several buildings. The site is one model, and each building is a separate model linked in turn to the site. When we get the site elevations and sections, the door swings show even when they should be hidden. We have observed that this happens with linked files. Has anyone encountered this problem? Any workarounds, suggestions?

Thanks,

Carlos

[beegee]

Door swings are not available as a visibility category in linked model files.

[sifuentes]

I have to rephrase the original post:

The problem actually occurs when printing. The site elevations and sections display OK, but the swings that should be hidden are coming out in the prints. Any suggestions?

Thanks,

[beegee]

The section / elevation cut lines could be intersecting door swings where the door panel in the those families has not been set to hide in elevation / 3D ?