Printable View
Hello everyone! I pretty new to this forum though I've been lurking for a while now. I'm trying to create roof framing from which I can schedule actual lumber takeoffs. (i.e., quantity of 2x6x8, 2x6x10, etc.). I've accomplished this through modeling but the procedure to get each piece of lumber in place is very cumbersome. The beam tool is nice but it only snaps to structural walls. My rafters extend from eave to ridge, neither of which a beam will snap to. Any ideas?
Try making up your own framing families if the families in the structural library don't work for you.
Attached is a rafter family that I use when I want to see the framing. Creating the rest of the pieces is not that bad, & they'll schedule out. You could add some parameters to the rafter to get out things like board length, etc.
I am new to Revit so I hope my question isn't silly.
How would one go about using this rafter family. I have put roofs on using the footprint method. Is this used in addition to a normal roof extrusion.
You can use this in addition to a footprint roof or you can have the footprint roof just represent the outer layers of the roof <sheathing shingles, etc... and place the framing underneath.
Not sure which I would do as we don't do wood roof framing plans <commecial steel>
Andrewg-
Nice rafter family. I'm using one similar. The problem that I am having is getting certain members in place, particularly jack rafters. How do you handle these?
Thanks for the compliment.
I'll have to think about that. How about a family that's an assembly of the hip ridge & associated jack rafters? If these pieces are nested families, I'm not sure how they'll schedule out.Quote:
particularly jack rafters. How do you handle these?
Might be able to do the same for framed openings, an assembly of the rafters & other framing members associated with the opening.
A while ago I was playing around with nesting structural members in the window families. I was new and there were some obvious mistakes made...i.e. structural members in a window family don't make a whole lotta sense. But at least it allowed me to put in a header, jack studs, etc. and always have it in the right place. same could be done for doors and other openings.
Thanks for the input. My understanding is that families nested in a family do not schedule.
Therein lies the rub
:(
Hello everyone! I pretty new to this forum though I've been lurking for a while now. I'm trying to create roof framing from which I can schedule actual lumber takeoffs. (i.e., quantity of 2x6x8, 2x6x10, etc.). I've accomplished this through modeling but the procedure to get each piece of lumber in place is very cumbersome. The beam tool is nice but it only snaps to structural walls. My rafters extend from eave to ridge, neither of which a beam will snap to. Any ideas?