Re: Publish To PDF Settings - Where and How?
I have created a saved setup with the correct layout and settings, and that is the only one in my .dwt file that is mapped to my SSM for the "Plot with page settings overrides.
But - in the sheets, there are about 4 or 5 saved plot settings (full pdf, half pdf, full plotter, half printer, etc) and if one of these is active - the "Publish to PDF" from SSM uses that setting. That was what I was running into.
Re: Publish To PDF Settings - Where and How?
Which is _exactly_ why I always use the Publish dialog box -- relying on everyone (including me) to leave the drawing with the 'correct' page setup active is simply not realistic. the seconds save by using one-click publish is more than lost by re-doing the publish job