Hi all,
If I want to enter the length of a wall, cool, I get it. How about the length and the angle before I finish the wall?
Searched through documentation and a bit on AUGI, cannot seem to find it.
Is the answer out there?
Thanks,
Chris
Printable View
Hi all,
If I want to enter the length of a wall, cool, I get it. How about the length and the angle before I finish the wall?
Searched through documentation and a bit on AUGI, cannot seem to find it.
Is the answer out there?
Thanks,
Chris
If, when creating the wall, you leave one end unconnected, you can then highlight the wall and it's angle relative to the connected wall will show, and is editible. Once you've set the angle, you can attach the other end by dragging or trimming...
but what if i am drawing my first wall and i know i want it to be 30' and 12 degrees off. Can't I just input that?
I dont think so - this is something i've wanted to do fore ages.
Would be cool if you could somehow tab through which dimenion you wanted to enter, instead of it always automatically taking the length.
Drawing a box for example, it doesnt even know which dimenion you are typoing so takes neither!