DOT linetype - require dot every foot along objects.
i'm trying to use the 'dot' linetype in a plan and profile drawing, and i cannot get the dots to line up where i want them. i want there to be one dot every "foot" on the profile and can't seem to get it to land where i want. does the linetype scale line up somehow with your drawing scale, or do you just have to experiment until you get it?
RE: DOT linetype - require dot every foot along objects.
Hi
I assume you have played with / read up on the below system variables...
CELTScale
LTScale
PSLTScale
Have a good one, Mike
RE: DOT linetype - require dot every foot along objects.
Quote:
Originally Posted by okillham
i'm trying to use the 'dot' linetype in a plan and profile drawing, and i cannot get the dots to line up where i want them. i want there to be one dot every "foot" on the profile and can't seem to get it to land where i want. does the linetype scale line up somehow with your drawing scale, or do you just have to experiment until you get it?
I use a version of Roberts method. No offence Mike but if someone else comes along and changes any of the SYSVARS it FURBARS the drawing.
Depending on what you want, make a block (Again just in case the SYSVARS get changed) out of a circle or a donut and then use the MEASURE command to space them at 1 foot intervals.
Also if you don't want the line to plot put it on a "noplot" layer and the end product will only show the dots without you needing to erase the line. (Because we all know that the alignment will change at least 4 times before the eng. finally makes up their mind)
RE: DOT linetype - require dot every foot along objects.
Quote:
Originally Posted by jmelanson
Also if you don't want the line to plot put it on a "noplot" layer and the end product will only show the dots without you needing to erase the line. (Because we all know that the alignment will change at least 4 times before the eng. finally makes up their mind)
Only 4? I am jealous. LOL
RE: DOT linetype - require dot every foot along objects.
Quote:
Originally Posted by cwade
Only 4? I am jealous. LOL
:veryevil: They learned the hard way to keep changes to a minimum.....:veryevil: