Subassembly

I am in a coastal low plain and the roads are going to mostly be nearly 3 ft above existing grade. I want to generate 2ft ditches but I don't want the foreslope top point to begin until existing surface. I see the BasicsideslopeCutDitch sub-assembly covers that scenario ideally with the cut slope mode. I will need to do additional grading when my sub-assembly ends up in fill mode.

Whats the best practice for that?

I wish there were a way to add another sub-assembly to BasicsideslopeCutDitch and have it apply only in fill slope mode. Is that possible?

Quote:

---

Originally Posted by tim_newsome

I am in a coastal low plain and the roads are going to mostly be nearly 3 ft above existing grade. I want to generate 2ft ditches but I don't want the foreslope top point to begin until existing surface. I see the BasicsideslopeCutDitch sub-assembly covers that scenario ideally with the cut slope mode. I will need to do additional grading when my sub-assembly ends up in fill mode.

Whats the best practice for that?

I wish there were a way to add another sub-assembly to BasicsideslopeCutDitch and have it apply only in fill slope mode. Is that possible?

---

Hi man give me a shout, i can custom make this for you in Sub-Assembly composer.

there is, investigate use of CONDITIONAL assemblies,

it will 'test' the condition and apply the assembly you specify for that condition