2 Attachment(s)
Placing point loads on plates and getting results
Hello.
I have a edge supported steel deck plate and I have placed 2 point loads on it. When I run Verification i get no errors but when I run the analysis I get the attached error and no results (all load effects = 0)
Why?
Also I used a fixed line support along the long edges but when the plate was meshed the support symbols changed, for what it is worth.
Thanks,
TT
1 Attachment(s)
Re: Placing point loads on plates and getting results
As a follow up, I generated some results but the only values I have is for deflection, the plate stresses are still showing zero (in red type lower right). See attached screen shot.
TT