After running igesout command from MDT I have to reset to my vanilla AutoCAD profile

Printable View

2007-01-05, 01:46 PM
robert.1.hall72202

After running igesout command from MDT I have to reset to my vanilla AutoCAD profile

Everytime I run MDT to do an igesout, I have reselect the vanilla profile the next time
I click on my shortcut to run AutoCAD.

Is there a specific reason this happens?

MDT is run from a separate shortcut than Vanilla.
I do not that the Vanilla shortcut would open as MDT.

Suggestions?
2007-01-05, 02:23 PM
BrenBren

RE: MDT/Vanilla

Quote:

Originally Posted by Robert.Hall

Everytime I run MDT to do an igesout, I have reselect the vanilla profile the next time
I click on my shortcut to run AutoCAD.

Is there a specific reason this happens?

MDT is run from a separate shortcut than Vanilla.
I do not that the Vanilla shortcut would open as MDT.

Suggestions?

You aren't calling a profile from the shortcut, are you, using the \p switch?
2007-01-05, 02:50 PM
robert.1.hall72202

RE: MDT/Vanilla

Quote:

Originally Posted by BrenBren

You aren't calling a profile from the shortcut, are you, using the \p switch?

No, but I probably should.
I am guessing that would fix the problem.
2007-01-05, 03:09 PM
BrenBren

RE: MDT/Vanilla

Quote:

Originally Posted by Robert.Hall

No, but I probably should.
I am guessing that would fix the problem.

Worth a try ~shrug~
2007-01-05, 09:52 PM
robert.1.hall72202

RE: MDT/Vanilla

I tried loading a profile using the shortcut but then I had to appload
all of my lisp routines. Ouch! Is there something I need to do
with the lisp files? I have them in the startup suite.
2007-01-05, 10:07 PM
BrenBren

RE: MDT/Vanilla

Quote:

Originally Posted by Robert.Hall

I tried loading a profile using the shortcut but then I had to appload
all of my lisp routines. Ouch! Is there something I need to do
with the lisp files? I have them in the startup suite.

Are you pointing to the folder where the lisp files are in your support files?

Did that make sense? Under files, support files, you have to show the folder where the lisp files are.
2007-01-08, 01:12 PM
robert.1.hall72202

RE: After running igesout command from MDT I have to reset to my vanilla AutoCAD profile

Yes, it points to the correct folder. I don't think I will ever figure out what
AutoCAD is up to. I loaded it up the morning with the profile shortcut and
was missing all but 2 of the toolbars. After resetting the profile, the missing
toolbars appeared.

No matter what I setup, I think the software has a mind of its own!

All times are GMT. The time now is 10:01 AM.