i have a revit 3d modeling thread i wish to post but have not found the proper sub category.
any ideas?
|
i have a revit 3d modeling thread i wish to post but have not found the proper sub category.
any ideas?
I guess that would depend on the content of the thread...
i have a non-2d path glass roof/canopy. i have been trying to model a structural beam around the edge (curved, think z coordinate) and have had no luck.
I would think you could try either the Revit Architecture - General or the Revit Structure - General forums. If it is still in the wrong area, maybe a moderator can assist in placing it where they think you will get the most help.
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt