Wall Height Profile

[vkumar.205005]

Has any one used this "wall height profile" feature?

Apparently we could use profile, 3D Polyline, or feature to se the wall height.

But where do we define this? Face of the wall or back of the wall?

I could not find any documentation in the help file regarding where to define this?

[jpaulsen]

I am unfamiliar with the "wall height profile" feature that you are referring to. Where is it found in the menus?

[vkumar.205005]

'Wall Height Profile' is a 'target parameter' assocated with 'RetainWallVertical' (or any retaining wall) sub assembly.

[brian.hailey933139]

In the tool palette, right click on the subassembly and select help. It should tell you all about it.

[vkumar.205005]

There is not much info on the so called sub asembly help reagarding this.

[sinc]

When I check the help on that subassembly, I see a diagram showing all the pieces of the subassembly in both cut and fill situations, with the attachment points, then all the Input and Target parameters, complete with full explanations, and then a diagram of all the Point and Link Codes.

What further information do you need?

[brian.hailey933139]

I agree with Sinc, I get a ton of info from the help. In fact, this is what I see: http://i41.tinypic.com/3582hcx.png