How to convert a region into polyline.
When I tried to make boundary for an ellipse segment in an object it converts into region.
Any solution for it.?
|
How to convert a region into polyline.
When I tried to make boundary for an ellipse segment in an object it converts into region.
Any solution for it.?
I dont think you can with an ellipse, you could try offsetting the ellipse 1 unit out, then 1 unit back in to get a spline approximation of the ellipse, and then in 2009 bonus pack 1 and later, convert the spline to a polyline, or just use flatten on the spline to convert it to a polyline.
Thanks for you reply and suggestion.
But my need is to convert a region into closed polyline. How?
If you convert an ellipse to a region then explode the region you get an ellipse and you cannot explode an ellipse unless PELLIPSE was set to 1 before the ellipse was created.
So, explode the region(s) to ellipse(s). Wblock the ellipse(s) to a temporary file and delete the region(s)/ellipse(s) from the working file. Open the temporary file and save it in R12DXF format - this will convert ellipses to polylines. Close the temporary file. Re-open the temporary file and save it normally (as dwg) then insert it into the working drawing.