Hello i am new at Cvil 3d. When I make corridor on my surface I do not get show the excavations and embankments on side of my road. And I dont konw what I am doing worond.
Thanks Aleks
|
Hello i am new at Cvil 3d. When I make corridor on my surface I do not get show the excavations and embankments on side of my road. And I dont konw what I am doing worond.
Thanks Aleks
Without looking at your file, I would guess that you need to target the existing ground surface for your daylight subassembly.
I second what Brian said, you have no targets in your corridor properties.
Go to the Parameters tab In the corridor properties and pick the Set All Targets button. You should see Surfaces listed under Targets. Pick where it says <Click here to set all>. If you do not see surfaces listed you need to add a subassembly that can target a surface to your assembly.
ok perfect i made it. Cool thanks.
But now i have a problem to export it because when i export it to xml or vsp3d i get error by corridor. What i am still doing wrong? What did i miss / overlooked??
P.S: Picture of error!!