Action Overload?

[jbuss]

I am attempting to assign three actions to the same linear parameter and i am having trouble doing all three at once. I have a door with frames on either side (not attached), a rectangle for the door and an arc for the swing path. My goal was to put one linear parameter across the opening of the door and then change the length of the door as i change the opening. I am having limited success. Is there a limit to the number of actions per parameter?
I am using Auto CAD 2009 Education Version, on XP.

Jason

[jnoon]

I have never found a limit to the number of actions yet and for a couple applications have about a dozen actions dependent on each other.

If you post a sample of your work someone may be able to figure out where your problem lies, of course there may be issues with the education version I am unaware of.


john

[jbuss]

Here is a drawing with two blocks i attempted to set up in the same way but are functioning differently. There could be some setting that i am missing but i don' t know for sure. Let me know what you think.

jason

[jnoon]

I think I solved one problem with a move action, this seems to work better than a stretch attached to a stretch.

john

[jnoon]

I think this sample may be what your after, no tpositive but it may be from this board.

John