I am drawing a blank this morning....
I want to place a macro on a button that will isolate a layer that is named in the macro, run a command, select all, then restores the layer state....
I have been away from this way too long...
TIA
Tom
|
I am drawing a blank this morning....
I want to place a macro on a button that will isolate a layer that is named in the macro, run a command, select all, then restores the layer state....
I have been away from this way too long...
TIA
Tom
Why not do make a selection set [ssget] and filter it based on the layer?
If you have a technical question, please find the appropriate forum and ask it there.
You will get a quicker response from your fellow AUGI members than if you sent it to me via a PM or email.
jUSt