Results 1 to 3 of 3

Thread: closure calculation frustration.

  1. #1
    Woo! Hoo! my 1st post
    Join Date
    2010-01
    Posts
    1
    Login to Give a bone
    0

    Default closure calculation frustration.

    Trying to produce closure calculations for a sub map I am drafting in C3D 2010. As the drawing was started in LDD 2007, none of the lots were created in the current version of ACAD I am using. How do I go about getting closure calcs? Is entering the northing and easting for each point the only way I can get this done?

  2. #2
    AUGI Addict sinc's Avatar
    Join Date
    2004-02
    Location
    Colorado
    Posts
    1,986
    Login to Give a bone
    0

    Default Re: closure calculation frustration.

    Have you created Parcels yet? If not, start by doing that. Then you can get analysis in various ways, such as in the Parcel Properties, or right-click on the Parcels in Prospector, or use a Report.

  3. #3
    All AUGI, all the time brian.hailey933139's Avatar
    Join Date
    2006-12
    Location
    Loveland, CO
    Posts
    734
    Login to Give a bone
    0

    Default Re: closure calculation frustration.

    You can also label the lines and use the mapcheck tool.

Similar Threads

  1. Opening's wall closure
    By mtogni in forum Revit Architecture - Families
    Replies: 0
    Last Post: 2005-01-11, 05:35 PM
  2. Opening's wall closure
    By mtogni in forum Revit Architecture - General
    Replies: 0
    Last Post: 2005-01-11, 05:35 PM
  3. Desperately seeking Closure
    By T_Livingston in forum VBA/COM Interop
    Replies: 13
    Last Post: 2004-11-12, 04:27 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •