Results 1 to 3 of 3

Thread: Metric to Imperial in MEP HVAC Design

  1. #1
    Member
    Join Date
    2009-03
    Posts
    3
    Login to Give a bone
    0

    Default Metric to Imperial in MEP HVAC Design

    I have MEP 2009, and while the duct is sized in Imperial inches, the design data like friction loss and flow is in metric in the properties box. How do I switch it to Imperial CFM and inches of water?
    Also, how do I get it to use only even sizes in ducts and not odd like 7" or 11"?

  2. #2
    Woo! Hoo! my 1st post
    Join Date
    2008-03
    Posts
    1
    Login to Give a bone
    0

    Default Re: Metric to Imperial in MEP HVAC Design

    Please any one can help me in this mater

    i face same problem

    thanks

  3. #3
    Member
    Join Date
    2010-07
    Posts
    4
    Login to Give a bone
    0

    Default Re: Metric to Imperial in MEP HVAC Design

    Only available in 2012 MEP and above http://ideatesolutions.blogspot.com/...tures-for.html

Similar Threads

  1. Metric to Imperial
    By ..shaner in forum Revit Architecture - General
    Replies: 2
    Last Post: 2009-08-21, 06:43 PM
  2. Imperial to Metric
    By rhayes.99001 in forum ACA General
    Replies: 1
    Last Post: 2008-06-18, 08:36 PM
  3. Metric vs Imperial
    By sbrown in forum Revit Architecture - General
    Replies: 20
    Last Post: 2004-01-27, 05:53 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •