Rebar shape

[annie123]

Dear all,
I am using rebar shape 67 in my project. when I give the radius, it gives the radius from center of rebar. but I want it from internal side of rebar. please check the attached image.

Regards
Annie

[TheViking]

Dear all,
I am using rebar shape 67 in my project. when I give the radius, it gives the radius from center of rebar. but I want it from internal side of rebar. please check the attached image.

Regards
Annie

The family editor for rebar only displays the centerline of a bar. However, when the bar is loaded into the project Revit performs a little magic with the bars. All dimensions are measure to the outside face of a bar except in the case of a bend. Bends are measured to the inside face. This is done to follow code and the convention for how the bars are fabricated. Bends are usually created by bending the bar around a pin. The pin radius matches the bend radius.

You also indicate a rebar shape code of 67. Which code are you using and can you share?

Thanks,
Erik

[annie123]

The family editor for rebar only displays the centerline of a bar. However, when the bar is loaded into the project Revit performs a little magic with the bars. All dimensions are measure to the outside face of a bar except in the case of a bend. Bends are measured to the inside face. This is done to follow code and the convention for how the bars are fabricated. Bends are usually created by bending the bar around a pin. The pin radius matches the bend radius.

You also indicate a rebar shape code of 67. Which code are you using and can you share?

Thanks,
Erik

Thanx Eric,

I am attaching the image of Rebar Shape which is required for my new project. I am not able to ceate this rebar shape in Revit.
Any help?

[swmarais]

This may help... It is a standard shape in our country

[annie123]

Thank you dear,
check the attached image, i need arc instead of line. if you have that shape please post it.

Regards
Annie

[krystian.kwinta]

Hello,
Unfortunately I have not got a solution for You Annie (I am really new in Revit), but I have got a question...
How do You use rebars in Revit? Is it possible to make a RC detailing drawings. I have heard that Revit is mainly useful in making project - not for reinforcement detailing.
Could anybody attach a screen shot of that kind of drawing.....
Regards
Krystian

[TheViking]

Thanx Eric,

I am attaching the image of Rebar Shape which is required for my new project. I am not able to ceate this rebar shape in Revit.
Any help?

I will test. Can you post an image of the concrete element or elements this will be used in?

Thanks,
Erik