Results 1 to 1 of 1

Thread: Surveyor's units with dynamic input doesn't display correctly

  1. 2010-02-19, 10:31 PM #1
    AAllison.Bell
    AAllison.Bell is offline
    Member
    Join Date
    2008-12
    Posts
    5
    Login to Give a bone
    0

    Default Surveyor's units with dynamic input doesn't display correctly

    Hello,
    I'm using AutoCAD Map 2009 & LDD 2009 and have my AUNITS set to Surveyor's Units. When I use dynamic input it displays the angle as a decimal instead of as the surveyor's units. It was working correctly up until a few months ago, but then something must have changed. I have also noticed that if I have the dynamic input off, then start the line command, and then turn on the dynamic input while I'm still in the line command it will display the angle correctly. But if dynamic input is already on when I start the line command, then the angle will display it incorrectly as a decimal. (see attached screenshots) Does anybody know how to fix this?
    Thanks in advance,
    Allison
    Attached Images Attached Images
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 2013: a surveyor unit input question
    By utakecare2003 in forum AutoCAD General
    Replies: 3
    Last Post: 2014-11-05, 03:19 AM
  2. Lisp Routine: Decimal to Surveyor Units
    By Firmso in forum AutoCAD Customization
    Replies: 8
    Last Post: 2009-02-20, 09:31 PM
  3. Getting Attributes to display correctly once Dynamic Block is instead more than once
    By kcrum in forum Dynamic Blocks - Technical
    Replies: 10
    Last Post: 2008-03-06, 12:49 AM
  4. Surveyor's units and directions
    By chuck_cantieny in forum AutoCAD General
    Replies: 4
    Last Post: 2005-03-23, 11:43 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules