Hello,
I'm using AutoCAD Map 2009 & LDD 2009 and have my AUNITS set to Surveyor's Units. When I use dynamic input it displays the angle as a decimal instead of as the surveyor's units. It was working correctly up until a few months ago, but then something must have changed. I have also noticed that if I have the dynamic input off, then start the line command, and then turn on the dynamic input while I'm still in the line command it will display the angle correctly. But if dynamic input is already on when I start the line command, then the angle will display it incorrectly as a decimal. (see attached screenshots) Does anybody know how to fix this?
Thanks in advance,
Allison