See the top rated post in this thread. Click here

Results 1 to 3 of 3

Thread: Converting Revit splines to AutoCAD splines

  1. #1
    100 Club
    Join Date
    2008-12
    Location
    West Roxbury, MA
    Posts
    124
    Login to Give a bone
    0

    Default Converting Revit splines to AutoCAD splines

    Hi,

    I recently converted a 3D form based on a spline from Revit 2009 to AutoCAD so someone using AutoCAD could use it.

    However, the curve of the spline became dramatically altered during the conversion.

    Have others encountered this problem, and is there a work-around? I've been searching the threads and it sounds like most of the issues have been centered around converting from the other direction.

    The attached files illustrate the problem.

    Thanks,
    Derek
    Attached Files Attached Files

  2. #2
    I could stop if I wanted to
    Join Date
    2015-11
    Location
    standing @ the crossroads
    Posts
    241
    Login to Give a bone
    1

    Default Re: Converting Revit splines to AutoCAD splines

    Try selecting the spline in Revit and add CONTROL POINTS to the spline from the EDIT SPLINE PANEL in the CONTEXTUAL TAB.

    You may need to add a few control points to get Autocad to read the spline the same as Revit............

  3. #3
    100 Club
    Join Date
    2008-12
    Location
    West Roxbury, MA
    Posts
    124
    Login to Give a bone
    0

    Default Re: Converting Revit splines to AutoCAD splines

    Thank you, appreciated!

Similar Threads

  1. 2013: Zero-tolerance splines in Revit 2013
    By pedrocty2001343477 in forum Revit Structure - General
    Replies: 2
    Last Post: 2013-01-08, 09:43 AM
  2. 2013: Bringing in Polylines & Splines from Autocad Drawings
    By Argyll9846 in forum Inventor - General
    Replies: 3
    Last Post: 2012-06-14, 10:26 PM
  3. 3d Splines into Revit Structures
    By duncan.cox426162 in forum Revit Structure - General
    Replies: 4
    Last Post: 2011-11-15, 04:42 PM
  4. Revit Splines Are A Joke
    By Limbatus in forum Revit Architecture - General
    Replies: 1
    Last Post: 2011-06-27, 06:00 PM
  5. Converting splines to polylines?
    By matt.143284 in forum AutoCAD LT - General
    Replies: 4
    Last Post: 2007-08-31, 12:47 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •