I have attempted to create a steel truss family so the overall profile of the truss fits within a given set of dimensions. I have drawn the truss family profile to represent the overall out-to-out dimensions. Typical truss dimensions are as follows: c/c span=94'-7";
heel height at bearing 1'-6 1/2"; gable truss profile; top chord slope 5:12; truss height at midspan=21'-3". Top and bottom chords are WT's with dbl L's as web members. When I load the truss family into the project, draw the truss in plan and view it in elevation or section, the dashed line representation of the truss is on the centerline of the members which makes the overall dimensions of the truss larger than desired. Being new to Revit, I'm sure the answer to my problem is rather simple. All suggestions are very much welcomed.