ActiveX Error Help....?

[CADdancer]

Hello AUGI Members,

I am trying to use the MakeTable.lsp program which was a free download from the Cadalyst site. However, whenever I run the code I get the following Error Message:

MAKETABLE Error: ActiveX Server returned an error: Parameter not optional....!

Has anyone seen this error before....?? Any recommendations on how to eliminate the error message....??

Any help will be appreciated...!


Regards,
Vince

[Opie]

Have you debugged this program through the VLIDE?

[msretenovic]

The error occurs on line 410. The variable colleft is nil - this value is required and must not be nil. It is set on line 375 ONLY if the variable txtstr contains the value "DESCRIPTION". You can modify this by doing the following (line numbers are for reference only):

374 | (if    (= txtstr "DESCRIPTION")
375 |   (setq colleft col)
376 |   (setq colleft 0)
377 | ) ;_ end of if

The portion in red is the part I added.

HTH,

[CADdancer]

Hi Michael,

Thank you very much for you quick and accurate solution to my post. I inserted the line of code as you outlined and the routine created the table.

However, I am experiencing another difficulty with the program. Instead of the Title of the table being displayed on the top line the routine places the following text "CALCULATED CABLE DISTANCE" on the top line. Is there a solution to this anomolie....??

Once again thank you for your expert resolution to my first post.....!


Regards,
Vince