Fascia not mitering

[dzatto]

Why will my fascia not miter at my dutch hip (see attachment)? It miters everywhere else perfectly. Any ideas?

[Paul Monsef]

That's odd. I usually see that happen when the eaves do not align.

Did you forget to check "extend into core" on one side?

[dzatto]

That's odd. I usually see that happen when the eaves do not align.

Did you forget to check "extend into core" on one side?

I don't have that checked for any of them. Should I?

The only two it's not working on happen to be offset from the main roof 2' horizontally. Maybe that's messing it up?

[Paul Monsef]

I don't have that checked for any of them. Should I?

I generally like my roof slopes to start there. but as long as everything is consistant it doesn't matter.

The only two it's not working on happen to be offset from the main roof 2' horizontally. Maybe that's messing it up?

Could be, All three sides of that hip are offset 2'?

Can you upload the roof?

[dzatto]

I generally like my roof slopes to start there. but as long as everything is consistant it doesn't matter.

Could be, All three sides of that hip are offset 2'?

Can you upload the roof?

Well, the dutch hip part protrudes out 2' further than the rest of the roof.

Not sure how to upload just the roof. It's my first Revit project. Still learning. Getting better though! lol

[Paul Monsef]

Or idrop.io the file if it's too large to post. I thought deleting everything but the roof in a copy would make the file size easier to deal with.