I noticed on 2010 and now on 2011 that I cannot fillet a line with a polyline.
On our LT2011 we can still do this, turning the item into 1 polyline. Therefore I assume it's a setting of some sort that I cant find.
Any ideas?
|
I noticed on 2010 and now on 2011 that I cannot fillet a line with a polyline.
On our LT2011 we can still do this, turning the item into 1 polyline. Therefore I assume it's a setting of some sort that I cant find.
Any ideas?
what about the current status of edgemode? is it on or off? (although it shouldnt matter for fillet)
If I'm working in large coordinate values, I see similar issues with plines. That's common w/ state plane coordinate systems and georeferenced drawings.
When using the command Fillet, there are several options in square brackets [Undo, polyline, Radio, Trim (Recorta), Multiple]. With the Trim(Recorta) option to activate or deactivate the Trim. When Trim (Recorta) mode is enabled, you can fillet a line and a polyline. Wen disabled then not produce the fillet (assuming, for example Radio 0).
Sorry if there are differences in the name of the options, because my Autocad 2011 is in Spanish.