Let's talk about piping systems. Up until now, I've primarily dealt with HVAC systems (the air side) and am now looking into piping systems. I have created a little test project with two chillers, two cooling towers, two boilers, two air handlers, and two pumps for each of the systems. See attached image. I have all of the piping showing the correct flows, even with the flow factors, but what I'm a little unclear about is where the pumps fit into the systems. I currently have the following systems defined:
CWS - Condenser Water Supply (condenser water from the cooling tower to the chiller)
CWR - Condenser Water Return (condenser water from the chiller to the cooling tower)
CHWS - Chilled Water Supply (chilled water from the chiller to the cooling coil)
CHWR - Chilled Water Return (chilled water from the cooling coil to the chiller)
HHWS - Heating Hot Water Supply (hot water from the boiler to the heating coil)
HHWR - Heating Hot Water Return (hot water from the heating coil to the boiler)
The connectors on the pump are set to "system", which from what I can tell means they inherit the system they are connected to. However, they are not actually part of the defined systems above. So, for example, if I click on a cooling tower and edit the CWS system, the pumps don't show up as being part of the system. If I click "add to system", and select a pump, I then have to select one of the two connectors. However, both connectors are part of the CWS system. So, based on this behavior, it appears to me that the pumps can't be added to one of the defined systems. That is fine because the systems function correctly, but in the Systems Browser, the pumps show up as "Unassigned" which, from everything I've ever heard about systems, is a no-no.
Sooooooo, they way I have it set up seems correct and makes sense to me, but I'm bothered by the fact that the pumps are listed as unassigned. Is this just the way it is, or am I missing something?