Results 1 to 10 of 11

Thread: Offsetting Fire Alarm Plan Symbols

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Login to Give a bone

    Lightbulb Offsetting Fire Alarm Plan Symbols

    Ok here is one, You have two fire alarm devices stacked (a pull station and a strobe). In plan view, if you offset one device out from the wall so you can see both devices, it actually is located out in the air when you look at them in a section view. If you don't offset the the device then you have one on top of the other in plan view. Any ideas how to have this work in both plan and section view? Thanks.
    Last edited by mswilliams; 2010-06-10 at 05:35 PM.

Similar Threads

  1. Fire Alarm in MEP?
    By mcoffman in forum AMEP General
    Replies: 8
    Last Post: 2012-09-10, 10:35 PM
  2. Looking for fire alarm symbols
    By ndiamo4669 in forum Dynamic Blocks - Technical
    Replies: 2
    Last Post: 2009-12-30, 05:19 PM
  3. Fire alarm circuit
    By pasteele in forum Revit MEP - General
    Replies: 8
    Last Post: 2009-07-30, 10:26 PM
  4. Fire Alarm Libraries
    By dhensley in forum Revit MEP - General
    Replies: 1
    Last Post: 2009-06-10, 04:32 PM
  5. Fire Alarm Symbol
    By Roger Evans in forum Revit Architecture - Families
    Replies: 3
    Last Post: 2006-11-10, 05:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts