Section Hatching

[davidwpiggott]

When creating a section view of an assembly in an IV DWG file, each adjacent part is hatched at a different angle. This is good sometimes, BUT, we need to be able to have all the hatchs' at the same angle. I can't seem to find a check box or anything simple ... any ideas?

[gofy]

Once you create the section hover over the hatching (it will show up red (if you are using default colors)) then right click and choose edit... Once the Edit Hatch Pattern dialog box appears you can set the angle you want the hatch to be at.

I know this is not a quick fix if you have a lot of hatching on the drawing, but at least it is a fix.