Hi, I am trying to design a building for thermal analysis, and when I run the "Calculate Inter-Zonal Adjacencies" I get this Warning message, I have no clue what it means in terms of how it affects the calculations. And I can't get freaking rid of it. I have tried removing the zone, recreating it by using "Draw zone", so I would guess with whole my heart that it is enclosed, because I can calculate the volyme. When I use the "off" button on some zones in the file and run the "Calculate Inter-~" it says the zones are fine, then when I put the zones back on and run the it again, this freaking message comes up again. I might add that my facade is round or more egg-shaped, can this be the problem? or have someone here any clue why and how to fix this mess