Results 1 to 2 of 2

Thread: Surfaces from Scanners

  1. 2010-07-13, 02:59 PM #1
    andrews.255919
    andrews.255919 is offline
    Woo! Hoo! my 1st post
    Join Date
    2010-07
    Location
    Canton, Ohio
    Posts
    1
    Login to Give a bone
    0

    Default Surfaces from Scanners

    We are using a Faro Scanner. Is anyone else using this scanner with 2011?
    Reply With Quote Reply With Quote
  2. 2010-08-05, 05:03 PM #2
    jmeyer.186809
    jmeyer.186809 is offline
    100 Club
    Join Date
    2008-06
    Location
    The Yay! (Bay Area, CA)
    Posts
    131
    Login to Give a bone
    0

    Default Re: Surfaces from Scanners

    scanners are usually used with specific software that can handle the processing and then imported into autocad. Are you using it directly?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. 2014: Compare Surfaces/Report Surfaces Through XREFFED Models
    By Jeff@BOC in forum AutoCAD Civil 3D - Surfaces
    Replies: 6
    Last Post: 2014-04-24, 12:39 PM
  2. Surfaces
    By Loc in forum AutoCAD General
    Replies: 1
    Last Post: 2009-10-20, 12:18 PM
  3. Help XEROX Scanners?
    By intocad in forum Hardware
    Replies: 4
    Last Post: 2005-08-05, 03:37 PM
  4. Suggestions on 11x17 scanners
    By bbapties in forum Hardware
    Replies: 10
    Last Post: 2004-08-26, 12:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules