Results 1 to 2 of 2

Thread: Surfaces from Scanners

  1. #1
    Woo! Hoo! my 1st post
    Join Date
    2010-07
    Location
    Canton, Ohio
    Posts
    1
    Login to Give a bone
    0

    Default Surfaces from Scanners

    We are using a Faro Scanner. Is anyone else using this scanner with 2011?

  2. #2
    100 Club jmeyer.186809's Avatar
    Join Date
    2008-06
    Location
    The Yay! (Bay Area, CA)
    Posts
    131
    Login to Give a bone
    0

    Default Re: Surfaces from Scanners

    scanners are usually used with specific software that can handle the processing and then imported into autocad. Are you using it directly?

Similar Threads

  1. 2014: Compare Surfaces/Report Surfaces Through XREFFED Models
    By Jeff@BOC in forum AutoCAD Civil 3D - Surfaces
    Replies: 6
    Last Post: 2014-04-24, 12:39 PM
  2. Surfaces
    By Loc in forum AutoCAD General
    Replies: 1
    Last Post: 2009-10-20, 12:18 PM
  3. Help XEROX Scanners?
    By intocad in forum Hardware
    Replies: 4
    Last Post: 2005-08-05, 03:37 PM
  4. Suggestions on 11x17 scanners
    By bbapties in forum Hardware
    Replies: 10
    Last Post: 2004-08-26, 12:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •