All,
I'm trying to apply a template to an alignment and the errors that I get are "No Vertical Exists" on every station.
What I've done:
I created an Alignment from a 3D Poly along the CenterLine of the Roadway.
I Sampled the Surface in the Cross-Section menu.
I then went to the Design Control Menu under the Cross-Section Menu and Edited the Controls.
Under Template Controls, I selected the Template that I wanted.
I set the slope parameters that I wanted; I think 3 min and max is 3:1?
I Process the sections
and Get the same error everytime.
The Autodesk Tutorial says that the "No Vertical Exists" error is due to a rounding issue at your end of alignment. My ending station is 1997.51, and I sampled up to 1997.5, and still I get this error.
Is there something I'm missing? When I view/edit my sections, all I get are a couple of lines and not the beautiful template that I designed.
Any thoughts?
Thanks in advance.
Youngster