Results 1 to 3 of 3

Thread: Unable to see Spline as I draw it

  1. #1
    Active Member
    Join Date
    2004-12
    Posts
    80
    Login to Give a bone
    0

    Default Unable to see Spline as I draw it

    I am trying to draw a spline. After I click to enter my first point, the previous segment disappears. I can then see the current line segment, but then when I click again to accept the point, the segment disappears and then I see the new line segment. This continues to happen until I close the group, and then I can see the entire thing. Has anyone else had this problem? I can't find anything documented about it anywhere.

    Thanks.

  2. #2
    The Silent Type Mike.Perry's Avatar
    Join Date
    2000-11
    Posts
    13,656
    Login to Give a bone
    0

    Default Re: Unable to see Spline as I draw it

    Hi

    What is DragMode set to?

    Have a good one, Mike

  3. #3
    Active Member
    Join Date
    2004-12
    Posts
    80
    Login to Give a bone
    0

    Default Re: Unable to see Spline as I draw it

    That was it Mike. Thanks for the quick reply.

Similar Threads

  1. 2015: Unable to offset a spline the has already been offset.
    By crullier in forum Inventor - General
    Replies: 1
    Last Post: 2014-12-19, 07:39 AM
  2. Im unable to draw reference planes anymore in my project......HELP
    By KMparker in forum Revit Architecture - General
    Replies: 2
    Last Post: 2012-09-24, 04:24 AM
  3. Unable to Draw Drafting Lines in Elevation
    By saeborne in forum Revit Architecture - General
    Replies: 2
    Last Post: 2008-12-24, 12:28 AM
  4. Replies: 1
    Last Post: 2008-06-18, 03:05 PM
  5. 3d spline?
    By yzhou in forum Revit Architecture - General
    Replies: 3
    Last Post: 2005-01-06, 03:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •